Re: Dynatherms Connected!
 

I may have downloaded the wrong mod. The one I downloaded was attached to llamabeast's last post with an attachment. I will start scouring the 44 pages for another one.

Re: Dynatherms Connected!
 

yeah i need to put a copy of the mod on the 1st post. llamabeast has a couple versions floating around in the thread. The correct one is the one right above this post.

Re: Dynatherms Connected!
 

I'm not sure if it's a mod issue or what...but I don't seem to have a start location. I see myself in the pretenders of the world list and I could send messages to people if I wanted to, but I have nothing in my nation overview and no province under my control. Is it possible that MA Tien Chi was not assigned a start location or did I just mess something up with my mods?

Re: Dynatherms Connected!
 

I have put what i hope is the barebones Kingmaker mod in the 1st post. Llamabeast included a few other mods in with it, and i tried to parcel those out.

All races got a starting province, unless there were more races than starting spots-which should not have occurred.

I just recounted the number of designated starting provinces on the map-61. As long as we had 61 or less races, everyone has a starting province.

It is like 2 am in London, so we need to wait until tomorrow before llamabeast can actually "look" and see what happened to ma tien chi.

Re: Dynatherms Connected!
 

That is BAD. I have seen this before. It means you had no valid start location. You will be dead next turn. Sounds like we need a restart http://forum.shrapnelgames.com/images/smilies/rant.gif

Re: Dynatherms Connected!
 

while i would not mind a reroll as my starting spot sucks, there is no reason with designated starting spots, for any race to not have a starting spot. We will have to ask llamabeast tomorrow(:

I just counted the races-there are 61 races. So I am stumped.

Re: Dynatherms Connected!
 

61 nations listed.

Re: Dynatherms Connected!
 

Have you seen the 6th Sense? I didn't want to be the one to have to tell you but you actually lost. http://forum.shrapnelgames.com/images/smilies/happy.gif

Re: Dynatherms Connected!
 

I got an awesome start location. Too bad I don't get to keep it now.

Re: Dynatherms Connected!
 

I think I found the issue and I am at fault. When editing the map, I designated a province to be a starting location that was a "no start" on the existing map file because it only connected to 1 province. After adjusting the neighbors, it was a good starting location, but I neglected to click off the "no start" designation. So it had both a designation as a starting spot, and a no start designation.

Maybe that is the issue?