Data entry for Grizzly(APC)
 

I was noticing the data for the Grizzly 6 wheeled APC and noticed something that is incorrect (for WinSPMBT v 4.5).

The calibers of the guns are correct one 50. cal MG and one GPMG 7.62 mm. The problem lays in its function. Having served in the Canadian military when the Grizzly was in use I have first hand experience.

Both guns are able to perform in the AA mode as well hence the large AA site on the outside of the vehicle. If the electrical system was damaged the gunner had use of two fast turning hand cranks for elevation and rotation.

There is also a depression override button so the guns could depress to a lower elevation in the event that enemy infantry would be attempting to place some sort of explosives on the vehicle.

We used to practice following fast air with our guns (no ammo of course) and it was easily done and lots of fun too.

Re: Data entry for Grizzly(APC)
 

Now corrected in the master. Change your guns with MOBHack to 55 and 53

Don

Re: Data entry for Grizzly(APC)
 

I am hoping this doesn’t seem like a silly question; once I figure out how to change the guns from cmg to aamg and I start playing email games, will that not show up with the other guy that I am playing against has something wrong?

Re: Data entry for Grizzly(APC)
 

Of course it will, in a secure PBEM - since it is now an altered OOB.

If you want to PBEM with edited OOBS, then exchange the OOB(S ) with your opponent before starting the secure PBEM game as explained in the Game Guide. And you may want to use the OOB swap facility to create a sub-folder with your edited OOB(s) to swap in and out with the official OOB set, again as described in the G/G (Game Installation / manage OOB sets).

Andy

Re: Data entry for Grizzly(APC)
 

Thanks for your help, the changing of the guns wasn't as easy as first thought.

I changed them to the AA guns but in the encyclopedia it still shows as cmg.

The mobhack looks like a good two or three hours of reading which I don't have time for in the summer time.

A small bit of advice would be appreciated.

Re: Data entry for Grizzly(APC)
 

Open MOBHack and click on Canada

Type Grizzly into the "Find:" box.

Change weapon 1 to 55 and weapon 2 to 53 for each of the three entires but after doing each one click on the red check mark BEFORE moving to the next unit. That sets the change.

After the third unit is done and you have clicked on the red check mark click on "Load/Save" tab then click on the SAVE button on the right side of the screen.

Then all your changes will be saved and you will see AAMG's in the encyclopaedia

Don

Re: Data entry for Grizzly(APC)
 

Very much appreciate your help.