Comrade Brian61, your next mission in the campaign is attached . . .
Quote:
Comrade, while you were able to capture the rail station north of Simga it appears that the enemy forces in the area have not been totally defeated. You will continue your advance under cover of darkness and finish clearing the rest of the road to the south however, be aware that our spies have reported the enemy massing for a midnight counterattack.**
While it will be dark during the mission, the weather is expected to be clear.**
Unfortunately a lack of supplies has forced us to halt any support from the armored train to your rear.**
You will have 8 Repair Points for this mission. When you add the Scenario to your Campaign, set the BUILD points for Node 003 to 8. Make sure you SAVE again after doing this.**
|
Mission #03
Install instructions:
Quote:
1) Unzip the C041_RED_ACTIONS_Brian61_002.zip file.
2) add U041i003.txt file to your winSPWW2 Campaigns folder.
3) add spscn053.cmt and spscn053.dat to your winSPWW2 Scenarios folder.
4) Start up your winSPWW2 game. Edit campaign 041 RED_ACTIONS Brian61 by adding scenario 053 into node 003 (the fourth scenario slot).
5) EDIT your BUILD points for Node 003 to 8.
6) Save your edit by pressing SAVE in the lower right hand side corner of the screen.
7) Save again. Make sure you have done this - if your edit (adding of next scenario) is not saved the campaign ends.
Go back to your last Saved Game file and continue the Campaign.
|
AGAIN: Make sure that you save the game before the battle ends, ideally the very last turn BEFORE the end result screen is shown. I would recommend saving to alternate slots each turn, just in case.
Please post your end game screen file here or email it to me at
doubledeuce@combat-campaigns.com