Re: Z Fire
Zovs post 27 gives the reason we looked into this but when we did we found it was doing things we had not intended
You can only Z-fire into Hexes you could see if they were in your LOS and you had the visibility to do so but it will no longer allow you to fire over obstacles and hit the hex behind the obstacle.
For example, if you have a MG with 40 range but the visibility is 10 and you are dug in on more or less flat ground then you could Z fire out to 40 hexes BUT if there are obstacles that even if you did have 40 visibility you could not shoot through then you will not be able to Z fire through or over them as they block LOS and all firing is done LOS.
Previously all kinds of things that would normally block LOS and normal firing had been "allowed" with Z-fire... the code drifted on us a bit over time because neither Andy nor I use Z-fire and if we did it was very conservatively but it's back to that we want now so all those old " house rules" about it's use should be tossed out the window
I am considering allowing the AI to Z-Fire if it takes Z-fire from a hex where the enemy is not yet seen but that is still at the " what-if" stage
|