In quotes are from my last post, with additional comment below...
"I used the following "
primary" units (As there were about 3 more.)"
I looked at a combination (USA/USMC) of 6 M1A1 ABRAMS.)
"IRAQ/M1A1 SA ABRAMS/UNIT 006//USMC/M1A1HC/UNIT 840//USMC/M1A1HC TUSK-T/UNIT 853//"
My
FINAL 3 of the 6 original tanks looked at.
"I choose to work with USMC UNIT 840 to
minimize the changes and it was
simply a better fit."
It hit the "
Sweet Spot" of the six that I would use a "
base model" to adjust from for a
reasonable M1A1 Export model.
USMC issue is a different matter and will need a further look later. Bottomline maybe only a 1/3 at best of the of the M1A1 saw conversion to the
FEP series the rest were simple m1a1 tanks and I felt that
USMC UNIT 840 fit the bill, which is why I submitted it new
END Date. I'm also looking at
TI/GSR 45 for
UNIT 840 but I need more info to support this.
Appreciate you used my numbers, needless to say I was ready for bed when done.
This just "popped up", but as you'll see if you read SLOWLY there's nothing, I haven't already mentioned concerning its problems over the years already.
https://www.armyrecognition.com/defe...ttlefield.html
Now it's time to get ready for you know what.
Regards,
Pat
