Map editor : little problem

[Austerlitz44]

Hello

At first many congratulations to the team of Winspww2 for their great work.My problem is in map editor. When i want to convert the streams into wide rivers with [ O ] and i try to regulate how wide i want to make it,in taping shift + the wished number, i obtain always the same width for all numbers from 0 to 9 . Probably i make a mistake . Someone can tell me what to do . Many thanks in advance.

excuse me for my very bad english

[DRG]

Ahh..... I see

Don't press Shift just enter the number

When the game asks you how wide you want to the river to be just press a number. Also remember you only get one shot at this. Once you've made a stream a wide river you cannot ask it to do it again becasue the stream is now gone

Don

[Austerlitz44]

Don

Many thanks for your answer . I just try it . Naturally it's better but I don't see a great difference beetwen the obtained width with numbers 1 and 9 for example . I must probably try again .

[DRG]

??? I walked through the procedure when I asnswered you the first time and produced a "9" wide map

When the game asks you .........

"Are you sure you wish to convert all streams to rivers? Y/N"

Press Y ( only Y )

when it asks you ........

"How wide do you want to make it? ( range is 0 - 9 ): "

press 9 ( only 9 ) not shift, not any other key and you will get a river 18 hexes wide. If you want an 8 hex wide river press 4. The numbers are set up to measure the river width from the centre to one bank.

Don

[Austerlitz44]

Sorry Don

I understood very well what you explain to me . I follow exactly your procedure and i press only 9 without shift and not other Key but i don't get a river 18 hexes wide . When i try the operation on other map in pressing 4 to obtain an 8 hex wide , i obtain the same with i obtaines before. I join to you two snaps which more speaking than me

[Austerlitz44]

Don

I join the other attachement