Map Editor : How to make "province inserted" work?

[llamabeast]

I can do this for you if you want. Post the .map and the desired number of the inserted province and I'll see what I can do.

[NTJedi]

The "inserted province" does not work at this time. Adding a new province can be accomplished, but depending on the location it can be a time consuming task.

[Edi]

You need to edit the map file by hand when you add new provinces.

Add the province where you want it, check the number of that province, then start from the end of the province list, with the highest number and change each number after the new province to 1 greater than it was. Needs to be done manually so as not to screw up possible terrain assignments, so find & replace is not an option.

Neighbors are easier, copy the neighbors section to a new text file and again start from the highest number down, change the numbers to 1 greater by find and replace (still takes a while to do, as I found out with the Faerun 466 map). When you're finished, check the borders to verify that everything went right.

If you need to remove a province and need to do things by hand, same drill, but you start by going up from the removed province and decreasing numbers by 1, same deal with border assignments and the find and replace, start from removed, decrease by 1 and move to next.

If somebody could write a script where the inserted parameters were the type of operation (add or remove province), the number of the province to be added or removed and then working as described above depending on which operation it was, it would be a very valuable tool for mapmakers.