Fully loading a vehicle AFTER the deployment phase

[Pyros]

Mike,

If you have two infantry units (for example A1 & A2) and one vehicle on the same hex and you wish to load both infantry units on the same vehicle you will need to do the following actions:

1. Check if the vehicle's carry capacity is bigger or equal to the total men of both units (UnitA1 number of men + UnitA2 number of men must be smaller of equal with the vehicle capacity). If the carry capacity is smaller than A1+A2 then you can't load both these units to the vehicle.
A carry capacity of 108 means that the vehicle may carry a total of 8 men, while a carry capacity of 112 means that the vehicle can carry a total of 12 men.

2. Select infantry unit A1 and press the LOAD button (or the "L") and then select the Vehicle.

Result: Now you should have one Infantry unit A2 and one vehicle (loaded with infantry unit A1)

3. Select infantry unit A2 and press the LOAD button (or the "L") and then select the Vehicle.

Result: Now you should have BOTH Infantry units loaded on the same vehicle.

cheers,
Pyros