Fully loading a vehicle AFTER the deployment phase

[Mobhack]

As Pyros says - with normal loading, to load multiple units into a carrier, you need to select the prospective passenger and "load to" the carrier vehicle, as once loaded, the load button if applied to the carrier will unload[ it.

See: Game Guide "Deployment menu", table of hot keys, and the note below it on the "L" key, "Note on loading and unloading".

The "load All" L-D sequence works at any distance in the deploy screen (turn 0). In the game itself, it works for all but the passengers must be in the same hex as the transport(s). Select one of the pax, and press L then D, and the entire platoon loads up, providing they are a) in the same hex as the transports and b) the load capacities are right (e.g. if there is one short squad and a team that need to load onto a single transport, the short squad and the team must be in the same hex). That is described in the next para of that part of the GG "Load/Unload options ".

(It is also mentioned in the "Deployment menu" section of the GG, but as a refernce back to this section)

Cheers
Andy

[MikeD]

jeeessshhh, I've been doing it backwards all along..
I've been doing load with the vehicle selected as in" "Bradley loads the infantry into itself"
Rather than: "Infantry (then missile team) loads into Bradley"